Short Throttle Adjust Tool

[jagtoolman]

Part no # 07908-4600200. For no6 carb sync.

Anybody know where I might source one from?

I've tried Louis, he has none. Any other suggestions?

Matt

[jnnngs]

Hi,

CMSNL has them:

http://www.cmsnl.com/products/wrench-ca ... ot6T4_XJhE

I recently bought one from:

http://www.bike-parts-honda.com/tarif_h ... &bb=Search

which was a cheaper, but was a special order and took 2 months or so to get it. Not sure how quickly CMSNL would get it - may be the same.

Paul.

[tevan]

I just made one..I just cut a standard length one down and rewelded it to the length that works under the frame.. Simple..

[Larry Zimmer]

Based upon some previous personal experience, CMSNL shipping will be 4 to 6 weeks. Could go to 2 months.

[steve murdoch icoa #5322]

I just made one..I just cut a standard length one down and rewelded it to the length that works under the frame.. Simple..

If you don't mind Tevan, how long did you make it? 4"?

[jagtoolman]

Thanks Guys.

Unless I can find one quicker / cheaper I might look at making something myself too.

Matt.

[tevan]

I made mine over all 4.5" long . The center of the ell lever to loosen the nut is 3.5" from the bottom of the tool. This works for me. Hope this helps others.

Terry

[Montana69]

Partzilla says they have them in stock for $65 http://www.partzilla.com/parts/detail/h ... 00200.html

[jagtoolman]

Thanks! Just ordered one from Partzilla.

[Goss]

I purchased one from my local Honda Dealer, it came from Honda Japan and it arrived 3 days later!

Regards

Goss

[Irishman1]

STill available from mother honda $65.00