The International CBX Owners Association

Part no # 07908-4600200. For no6 carb sync.

Anybody know where I might source one from?

I've tried Louis, he has none. Any other suggestions?

Matt

Hi,

CMSNL has them:

http://www.cmsnl.com/products/wrench-ca ... ot6T4_XJhE

I recently bought one from:

http://www.bike-parts-honda.com/tarif_h ... &bb=Search

which was a cheaper, but was a special order and took 2 months or so to get it. Not sure how quickly CMSNL would get it - may be the same.

Paul.

I just made one..I just cut a standard length one down and rewelded it to the length that works under the frame.. Simple..

Based upon some previous personal experience, CMSNL shipping will be 4 to 6 weeks. Could go to 2 months.

tevan wrote:I just made one..I just cut a standard length one down and rewelded it to the length that works under the frame.. Simple..

If you don't mind Tevan, how long did you make it? 4"?

Thanks Guys.

Unless I can find one quicker / cheaper I might look at making something myself too.

Matt.

I made mine over all 4.5" long . The center of the ell lever to loosen the nut is 3.5" from the bottom of the tool. This works for me. Hope this helps others.

Terry

Partzilla says they have them in stock for $65 http://www.partzilla.com/parts/detail/h ... 00200.html

Thanks! Just ordered one from Partzilla.

I purchased one from my local Honda Dealer, it came from Honda Japan and it arrived 3 days later!

Regards

Goss

STill available from mother honda $65.00