Comstar wheel restoration
-
- ICOA Member
- Posts: 15
- Joined: Fri Sep 17, 2010 6:46 am
- Location: Brisbane, Australia
- Location: Brisbane, Australia
Comstar wheel restoration
Sorry if this comes up twice, but i posted this question in the wrong category. I want to remove the five nuts and bolts from my 1978 rear wheel, have them zinc plated and reinstall. If i am carefull to use a tension wrench and reset them all would there be any problems. I was told these wheels were naver meant to be messed with? Thanks Les.
- Don
- Amazing Poster
- Posts: 806
- Joined: Wed Apr 02, 2003 3:13 pm
- Location: Biloxi, Mississippi, USA
- Location: Biloxi, Mississippi, USA
Re: Comstar wheel restoration
You're correct - Honda advises not to take them apart - That advice is stamped into many of the Comstars
If you did take one apart and intended to reassemble it, I'm sure they would advise you NOT to reuse the hardware . . . . but I'm pretty sure they also don't sell the hardware new, as they never intended anyone to reassemble any wheels in the field
Don
If you did take one apart and intended to reassemble it, I'm sure they would advise you NOT to reuse the hardware . . . . but I'm pretty sure they also don't sell the hardware new, as they never intended anyone to reassemble any wheels in the field
Don
-
- ICOA Member
- Posts: 15
- Joined: Fri Sep 17, 2010 6:46 am
- Location: Brisbane, Australia
- Location: Brisbane, Australia
Re: Comstar wheel restoration
Thanks Don, looks like my concourse restoration will fall a little short of perfect. I managed to get a brand new front wheel, but no luck sourcing a new rear one. Les.
- Don
- Amazing Poster
- Posts: 806
- Joined: Wed Apr 02, 2003 3:13 pm
- Location: Biloxi, Mississippi, USA
- Location: Biloxi, Mississippi, USA
Re: Comstar wheel restoration
The black boomerangs on my bike are not *exactly* the same - The rear one is factory black anodized with silver hardware . . . . the front one is powedercoated black and the hardware was painted silver to match the back. It's not perfect, but it's close enough that few would notice
If your rear wheel can be refurbished without disassembling it good enough to meet your standards, I'm pretty sure you could find some silver paint which matches your front wheel hardware that you could use on the rear wheel . . . . at least it would hold you over until you find the NOS wheel it sounds like you're looking for
Don
If your rear wheel can be refurbished without disassembling it good enough to meet your standards, I'm pretty sure you could find some silver paint which matches your front wheel hardware that you could use on the rear wheel . . . . at least it would hold you over until you find the NOS wheel it sounds like you're looking for
Don
-
- ICOA Member
- Posts: 230
- Joined: Thu Mar 06, 2003 10:51 pm
- Location: Goshen, IN
Re: Comstar wheel restoration
Not sure on your wheel but I have seen some that had a pin drilled in along the lenght of the bolt thread making removal of the nut near impossible.