Page 1 of 1
CB1100F swingarm needle bearings - supplier found
Posted: Sun Aug 09, 2009 3:34 pm
by bdento59
For anyone seeking new needle bearings for a CB1100F swingarm upgrade for an early CB-X project, I found a supplier.
With my trusty eye loupe, I was able to decipher the bearing code stamped on the old bearing. It is Koyo code # BTM2428, find it at
http://www.koyousa.com/KoyoCatalog/Prod ... 90-020-010
Posted: Tue Aug 11, 2009 6:47 am
by alimey4u2
We all thank you...
Posted: Tue Aug 11, 2009 12:07 pm
by bdento59
alimey4u2 wrote:We all thank you...
Well then, in that case, you're all welcome... <g> Of course, I realize that, as a relatively new CB-X owner, I may be the last person left who hasn't "already" done the CB1100F SA conversion. Be that the case, perhaps the information I supplied has a very limited audience. In any event, I wanted to put it out there.
Posted: Tue Aug 11, 2009 9:30 pm
by SteveG
Bill -
Please post any tidbits you find out about. Even if the limited audience consists of one CBXer being helped, it will be worth it.
Steve
Posted: Tue Aug 11, 2009 10:25 pm
by Terry
bdento59 wrote:alimey4u2 wrote:We all thank you...
Well then, in that case, you're all welcome... <g> Of course, I realize that, as a relatively new CB-X owner, I may be the last person left who hasn't "already" done the CB1100F SA conversion. Be that the case, perhaps the information I supplied has a very limited audience. In any event, I wanted to put it out there.
Not the last one yet I guess, pretty much stock here with thousands and thousands of miles to show for it on an early and late model.
Posted: Wed Aug 12, 2009 11:21 am
by alimey4u2
Some of "us" oldies need to be reminded on how to do things as it's been lost in the mist of time...
