Repro Wiring Harness Experience


Larry Zimmer
ICOA Web Post/Pix/Video Archive Mgt
ICOA Web Post/Pix/Video Archive Mgt
Posts: 2196
Joined: Mon Dec 15, 2003 2:32 pm
Location: Brighton, MI
Location: Brighton, Mich
Contact:

Re: Repro Wiring Harness Experience

Post by Larry Zimmer »

Good and interesting feedback. Thanks.
Larry Zimmer
cbxlarry@sbcglobal.net

divan
ICOA Member
ICOA Member
Posts: 38
Joined: Thu Jun 21, 2012 5:58 pm
Location: La Crosse, Wisconsin, USA
Location: La Crosse, Wisconsin, USA

Re: Repro Wiring Harness Experience

Post by divan »

Probably nobody would notice, but I want to correct a typo I made at the start of this post. Regarding the repro harness, I wrote: "I measured [the red] wire at 1.14mm, [diameter] though probably this could be 1.50mm, which would make this wire closer to 17 gauge. "1.50mm" should have read "1.150mm". A 1.50 mm cable would be closer to 12 gauge - Ha. Not likely here.

sisxiny0da -- I agree with you; good crimps make soldering unnecessary.
Dick Sullivan

User avatar
NobleHops
ICOA Member
ICOA Member
Posts: 3867
Joined: Mon Jan 25, 2010 7:17 am
Location: Tucson, Arizona, USA
Location: Tucson, Arizona, USA

Re: Repro Wiring Harness Experience

Post by NobleHops »

I did just edit the post using my admin privileges, (as the author you can too, by the way), please review and see that I did it correctly, and change it if I didn’t. Use the pencil button upper right in the post.

N.
Nils Menten
Tucson, Arizona, USA '80 CBX, sort-of restored :-)

User avatar
herdygerdy
Power Poster
Power Poster
Posts: 266
Joined: Fri Nov 22, 2013 9:48 pm
Location: Sydney, Australia
Location: Sydney, Australia

Re: Repro Wiring Harness Experience

Post by herdygerdy »

Great post Divan, very interesting and thank you for sharing your vast knowledge on this topic. I'm sure we are all very grateful for your contribution.

divan
ICOA Member
ICOA Member
Posts: 38
Joined: Thu Jun 21, 2012 5:58 pm
Location: La Crosse, Wisconsin, USA
Location: La Crosse, Wisconsin, USA

Re: Repro Wiring Harness Experience

Post by divan »

Thank you, Nils. Didn't know I could edit it myself. Your edit is what it should read.
Dick Sullivan

divan
ICOA Member
ICOA Member
Posts: 38
Joined: Thu Jun 21, 2012 5:58 pm
Location: La Crosse, Wisconsin, USA
Location: La Crosse, Wisconsin, USA

Re: Repro Wiring Harness Experience

Post by divan »

herdygerdy -- well, not so vast; I try to share the bits I have some understanding of, since I've learned so much about this bike from this forum over many years, including some of your posts. I'd say the collective knowledge of the CBX here is indeed vast, Thanks to all who contribute. Sincerely.
Dick Sullivan

Post Reply

Return to “ELECTRICAL: Alternator, Batteries, Headlights, Switches, Tailights, Wiring....”