Accelerator pump housing

Post Reply
mvanderwat
New Member & Happy To Be Here
New Member & Happy To Be Here
Posts: 4
Joined: Sun Feb 24, 2019 11:52 pm
Location: Wellington, New Zealand
Location: Wellington, New Zealand

Accelerator pump housing

Post by mvanderwat »

Hi. I have a 1981 CBX1000 Prolink and am looking for a 2nd hand accelerator pump housing.
Accelerator pump.jpg
I seem to have lost the inner 1-way valve in mine ?
1 way valve missing.jpg
Any help in sourcing a good 2nd hand one would be highly appreciated.

Cheers
Mark
You do not have the required permissions to view the files attached to this post.

CBX-tras
ICOA Member
ICOA Member
Posts: 237
Joined: Tue Feb 16, 2010 1:29 pm
Location: Clinton Twp, Michigan
Location: Clinton Twp., Michigan, USA

Re: Accelerator pump housing

Post by CBX-tras »

The heat and vibration in an ultrasonic cleaner can shake these apart, removing the square brass piece, spring and ball bearing that acts as a check valve. I no longer clean them in the machine with the rest of the parts for that very reason.
Although not sold as a service part by itself, it's the exact same component as any Honda DOHC 4 of that era.
Those may be easier to find in your area.

mvanderwat
New Member & Happy To Be Here
New Member & Happy To Be Here
Posts: 4
Joined: Sun Feb 24, 2019 11:52 pm
Location: Wellington, New Zealand
Location: Wellington, New Zealand

Re: Accelerator pump housing

Post by mvanderwat »

Many thanks for the reply. I think I may have found one off a GL1500 ?
I'll be more wary of my ultrasonic cleaner in future :)

CBX-tras
ICOA Member
ICOA Member
Posts: 237
Joined: Tue Feb 16, 2010 1:29 pm
Location: Clinton Twp, Michigan
Location: Clinton Twp., Michigan, USA

Re: Accelerator pump housing

Post by CBX-tras »

The parts are probably still in the bottom of the tank.

That cover was never sold as the single part, so, I can't confirm that the GL part will fit/function properly.

mvanderwat
New Member & Happy To Be Here
New Member & Happy To Be Here
Posts: 4
Joined: Sun Feb 24, 2019 11:52 pm
Location: Wellington, New Zealand
Location: Wellington, New Zealand

Re: Accelerator pump housing

Post by mvanderwat »

I'll let you know when I get it :)

mvanderwat
New Member & Happy To Be Here
New Member & Happy To Be Here
Posts: 4
Joined: Sun Feb 24, 2019 11:52 pm
Location: Wellington, New Zealand
Location: Wellington, New Zealand

Re: Accelerator pump housing

Post by mvanderwat »

CBX-tras wrote:
Tue Jun 28, 2022 5:32 pm
The parts are probably still in the bottom of the tank.

That cover was never sold as the single part, so, I can't confirm that the GL part will fit/function properly.
GL1500 part received and is a perfect match :)

Post Reply

Return to “CARBS: Cleaning, Rebuilding, Swaps, Aftermarket, Tuning, Syncing, and More”