Rifle windshield - what’s needed to revert to stock?

[NobleHops]

Possibly a dumb question, maybe not. We’re about to remove a Rifle windshield from an 82 project - including that plastic base. What are we going to need to restore the stock setup? Obviously a windshield, fasteners, and the two triangular painted upper fairing pieces, but is there anything else or any more subtlety to the project?

EDIT: Found the two fairing pieces, right where Phil left them for us in the saddlebag.

TIA,

N.

B2A9476B-A712-420B-9156-25A7F2659127.jpeg

[daves79x]

I think you have it figured out. FWIW - the Rifle, while not the best-looking shield compared to stock, is one of the very best for actual wind protection.

Dave

[EMS]

I am not sure if the Rifle used these, but the two front fasteners have small brackets with nuts incorporated, because it is hard to get to them.

[NobleHops]

Ya, we shall use well nuts when we reassemble this.

[EMS]

Don't understand how you would use "well-nuts"??