engine knock

Post Reply
MIKE DAVIS
Forum Regular
Forum Regular
Posts: 49
Joined: Thu Feb 25, 2016 12:35 pm
Location: SPARKS NV
Location: SPARKS NV

engine knock

Post by MIKE DAVIS »

anyone have experience with a loud,heavy,knock. Sounds like it's coming from the bottom end. Not a double-knock like a con-rod.Oil pressure light not on. Seems to run fine otherwise.

User avatar
FalldownPhil
ICOA Member
ICOA Member
Posts: 930
Joined: Fri Feb 10, 2006 11:25 pm
Location: Marina Del Rey, CA. USA
Contact:

Re: engine knock

Post by FalldownPhil »

Not a good noise :-(
Could be a bent rod with the piston skirt hitting the crank.
Best,
Phil
When you are up to your ass in alligators it is sometimes difficult
to remember that your objective was to drain the swamp !!

MIKE DAVIS
Forum Regular
Forum Regular
Posts: 49
Joined: Thu Feb 25, 2016 12:35 pm
Location: SPARKS NV
Location: SPARKS NV

Re: engine knock

Post by MIKE DAVIS »

the odd thing is that it ran just fine on an outing. Then I parked it and when I started it back up it was making this noise. I hadn't ridden it hard at all maybe 6000rpm on the first outing.

MIKE DAVIS
Forum Regular
Forum Regular
Posts: 49
Joined: Thu Feb 25, 2016 12:35 pm
Location: SPARKS NV
Location: SPARKS NV

Re: engine knock

Post by MIKE DAVIS »

I'm putting an MTC balanced crank and rod setup in it since I have to tear it down anyway. Just wondering?

steve murdoch icoa #5322
ICOA Member
ICOA Member
Posts: 4095
Joined: Tue Mar 04, 2003 9:12 am
Location: St. Catharines, On. Canada
Location: St. Catharines, On. Canada

Re: engine knock

Post by steve murdoch icoa #5322 »

If i had an MTC crank and rod set-up on the shelf i would be hearing non-existent engine noises.
Please report back when you do get into the engine.

User avatar
NobleHops
ICOA Member
ICOA Member
Posts: 3916
Joined: Mon Jan 25, 2010 7:17 am
Location: Tucson, Arizona, USA
Location: Tucson, Arizona, USA

Re: engine knock

Post by NobleHops »

steve murdoch icoa #5322 wrote:If i had an MTC crank and rod set-up on the shelf i would be hearing non-existent engine noises.
Please report back when you do get into the engine.

Steve made me spit out my Scotch! :laughing-lettersrofl:

Sorry about your bike, but it sounds like you have your solution in hand.

N.
Nils Menten
Tucson, Arizona, USA
'82 CBX, among others.

daves79x
ICOA Technical Director
ICOA Technical Director
Posts: 4832
Joined: Sun Oct 01, 2006 8:05 am
Location: Knox, PA
Location: Knox, PA

Re: engine knock

Post by daves79x »

That's how many hydro locks happen. Did you turn off your gas when you parked it? Remove 1 & 6 plugs and measure distance to each piston. Bent rod will show up very obviously.

Dave

Post Reply

Return to “X ...OTHER TECHNICAL: Won't Run, Centerstands, Chains, Fairings, Tanks, Gauges, Petcocks, Seats, Turn Signals, etc.”