Page 1 of 1
Fuel Feeder Tube for 79 CBX
Posted: Thu Jun 21, 2012 1:38 pm
by HondaJohn
I need a fuel feeder tube for a carb rebuild on a set of 79 CBX carbs - the one that goes between #5 and 6 carbs. I have one from a set of 82 carbs but discovered that it is larger in diameter, even though the bottom still fits the carb fuel orifices. If someone has the tube that I need, please let me know cost etc... Thanks.
Re: Fuel Feeder Tube for 79 CBX
Posted: Thu Jun 21, 2012 1:48 pm
by EMS
John,
I am a little confused about what you are actually looking for. Do you have a vacuum valve on your CBX?
The original 79 carb had only one tube from the petcock to the carburetors....
Re: Fuel Feeder Tube for 79 CBX
Posted: Thu Jun 21, 2012 2:06 pm
by daves79x
Ditto on Mike's reply - there is only one fuel inlet on the '79 carbs and yes, it is 1/4 inch vs the 5/16 inch on the two inlets for the '80-'82 carbs. Your '79 set should have just an aluminum connector between 5 and 6.
Dave
Re: Fuel Feeder Tube for 79 CBX
Posted: Thu Jun 21, 2012 2:13 pm
by HondaJohn
oops, I was looking at the wrong carbs. I have 3 sets in progress right now. got confused - need to take a break. Thanks for the comments.
Re: Fuel Feeder Tube for 79 CBX
Posted: Thu Jun 21, 2012 2:19 pm
by HondaJohn
Would I gain anything by putting another fuel tube between 5 and 6? The only one I have would be off of a cannabalized set of 82 carbs.
Re: Fuel Feeder Tube for 79 CBX
Posted: Thu Jun 21, 2012 3:16 pm
by EMS
HondaJohn wrote:Would I gain anything by putting another fuel tube between 5 and 6? The only one I have would be off of a cannabalized set of 82 carbs.
You would need a petock with a second outlet or add a "T" into the single line.
I can't say that there is absolutely no benefit to adding another fuel line, but I also can't see one that is obvious.
I used to hang around Harley guys a lot and to those who felt the need to shell out in excess of $100.- for a hi-flo Pingle petcock I always told this:
Fill your tank up fully. Disconnect the fuel line to the carb and route it into a large gasoline can.
Open the petcock and start a stop-watch.
Take the time it takes for the tank to drain completely- 20, maybe 25 minutes?
If your motor is capable of emptying the tank that fast, you need a high flow petcock.
Re: Fuel Feeder Tube for 79 CBX
Posted: Thu Jun 21, 2012 3:26 pm
by tevan
Very good explanation EMS and I agree with you 100%.............
Re: Fuel Feeder Tube for 79 CBX
Posted: Thu Jun 21, 2012 3:57 pm
by HondaJohn
Thank you. I am curious about that tank emptying.
Re: Fuel Feeder Tube for 79 CBX
Posted: Thu Jun 21, 2012 8:40 pm
by steve murdoch icoa #5322
John, i have read that only a BIG engine would require or benefit from the second gas line.