Barry,barryadam wrote:Can't tell from your pictures, but how's the bore condition? Especially at the end nearest the snap ring? The seal wiper doesn't quite come all the way back when assembled. And how does the snap ring groove area look after your clean up?
The bore is surprisingly pretty clean and smooth.
Only a small slightly rough area just at the bottom 1/2 inch of the bore. I don't think that's an issue since the bottom seal never gets down that far.
The snap ring groove area was pretty toasty as well. I got that really clean and smooth using a Dremel tool with a small wire brush attachment. So, I think I'm good there.
Thanks!