Hi guys.
What is the diameter of the stock speedo & tach? I'm shopping for replacements, and not sure if I should be getting 80mm, 85, 100, 3-3/8", 4", or what. I'll have the bike back and be able to take measurements in a couple of days, but if someone can provide the info here I can get the ball rolling a bit sooner.
Stock gauge diameter?
- Syscrush
- ICOA Member
- Posts: 1714
- Joined: Fri Sep 14, 2012 2:29 pm
- Location: Toronto, ON
- Location: Toronto, ON
- NobleHops
- ICOA Member
- Posts: 3867
- Joined: Mon Jan 25, 2010 7:17 am
- Location: Tucson, Arizona, USA
- Location: Tucson, Arizona, USA
Re: Stock gauge diameter?
Phil, the best measurement I could make was 105-107mm just behind the point they pass through the bracket. My calipers aren't deep enough to do it directly, but one of my wood clamps was . I gauged it with those and then measured the clamps with the calipers, hence the uncertainty. Hope that helps.
N.
N.
Nils Menten
Tucson, Arizona, USA '80 CBX, sort-of restored :-)
Tucson, Arizona, USA '80 CBX, sort-of restored :-)
-
- ICOA Member
- Posts: 4068
- Joined: Tue Mar 04, 2003 9:12 am
- Location: St. Catharines, On. Canada
- Location: St. Catharines, On. Canada
Re: Stock gauge diameter?
I get 3-5/8" for the yellow plastic underbody and 4-1/8" for the black outside ring looking at it from the front.
- Syscrush
- ICOA Member
- Posts: 1714
- Joined: Fri Sep 14, 2012 2:29 pm
- Location: Toronto, ON
- Location: Toronto, ON
Re: Stock gauge diameter?
Thanks for the effort, guys.