Page 1 of 1
Big Bore?
Posted: Sun Nov 12, 2023 5:26 pm
by relisysxx
Starting to look into rebuilding a CBXz motor that I bought in bits a few years ago, the standard bores are in pretty good order so I could just put a new set of rings on the original pistons but it also came with a 1150 big bore kit (new) AND a set of MTC high compression pistons in first over size (also new). Anyone have any experience on either of the options?
Re: Big Bore?
Posted: Mon Nov 13, 2023 8:42 am
by 80 cbx dude #6216
I'm currently using a set of cruisinimage 3mm oversize pistons and have almost 7,000 miles on them. I'm happy with them. No issues or complaints to report at this time.
Re: Big Bore?
Posted: Wed Nov 15, 2023 2:00 am
by relisysxx
Decided to go with standard bore and pistons so ordered up a new set of rings so the 'big bore' and high compression sets can go back on the shelf.
Re: Big Bore?
Posted: Wed Nov 15, 2023 8:20 am
by CBX-tras
relisysxx wrote: ↑Wed Nov 15, 2023 2:00 am
Decided to go with standard bore and pistons so ordered up a new set of rings so the 'big bore' and high compression sets can go back on the shelf.
Smart move.