Cam Bucket/Valve lifter conundrum


Post Reply
asjwalsh
ICOA Member
ICOA Member
Posts: 13
Joined: Sun Oct 27, 2019 4:06 pm
Location: Palm Coast FL, USA
Location: Palm Coast FL, USA

Cam Bucket/Valve lifter conundrum

Post by asjwalsh »

So I am doing a full engine teardown. This is my first CBX. I have the following problem. The head has 19 'A' stamps and obviously 5 'B' stamps.

The actual buckets that I took out of the head didn't match the stamps at all. In fact, I have 8 'A' buckets and 16 'B' buckets.

My best guess is that a previous rebuild was completed by someone who had no idea there were different buckets and mixed in some either new or donor buckets. What should I do, buy 11 'A' buckets thus honoring all the correct bucket to head matches or just put everything back where I found it? :mrgreen:

daves79x
ICOA Technical Director
ICOA Technical Director
Posts: 4738
Joined: Sun Oct 01, 2006 8:05 am
Location: Knox, PA
Location: Knox, PA

Re: Cam Bucket/Valve lifter conundrum

Post by daves79x »

If I had access to the correct buckets (I do), I'd change them. That said, mic the buckets and you'll see very small differences. I can't remember which are larger, A or B, but a smaller bucket in the larger hole, small as the difference is, won't hurt anything. I have a ton of extra buckets if you want to match them up.

Dave

Post Reply

Return to “ENGINES: Maintenance, Performance, Parts Sources”