Page 1 of 1

Exhaust gaskets,Which Side

Posted: Sat Apr 07, 2007 10:09 pm
by DevonCbx
I noticed that there is a little lip on one side of the gasket. Does this lip go towards the engine or towards the pipes. Thanks

Posted: Sun Apr 08, 2007 7:39 am
by steve murdoch icoa #5322
Are you using the copper or fibre gaskets?
I have never seen a gasket with a lip. A crushed copper gasket might look like it has a lip around the outside. I use them twice, turning them over for the second application.

Posted: Sun Apr 08, 2007 1:26 pm
by alimey4u2
steve murdoch icoa #5322 wrote:Are you using the copper or fibre gaskets?
I have never seen a gasket with a lip. A crushed copper gasket might look like it has a lip around the outside. I use them twice, turning them over for the second application.
It is advisable to anneal them ( soften them) prior to reusing, by heating to cherry red & dunking in a bucket of cold water.... I too wondered about the lip thing.. ??

Posted: Tue Apr 10, 2007 6:03 am
by cbxtacy
I think I've used the gaskets you're talking about. The copper goes around a fiber core and on one side it's rolled over itself. I do not believe which way they go in matters.

Posted: Tue Apr 10, 2007 7:31 pm
by Jeff Bennetts
I put the lip towards the head, but like George said I don't think it matters.

jb